MWK Mobility Weatherbar Kit 20 914mm - Black - Exitex
Fitting Instructions: Threshold Section Check width between inside faces of the doorframe rebate and cut aluminium section to this size. (See Illustration) Notch the front ramped section as below. (See Illustration) This sill requires an un…View more
You might be interested in Similar Products
Deflector 914mm Black - Exitex
from £35.93
Macclex Lowline Sill 914mm Black - Exitex
from £25.85
Macclex 15/2 Threshold 914mm - Black - Exitex
from £22.65
Macclex 15/56 Threshold 914mm - Black - Exitex
from £34.50
Slimline Threshold 914mm - Aluminium - Exitex
from £27.32
25mm Kleertred 914mm Gold - Exitex
from £53.36
20mm Kleertred 914mm Aluminium - Exitex
from £40.90
Exitex Macclex Lowline Sill 914mm Gold
from £23.78
OUM 4 Threshold 914mm - Gold - Exitex
from £25.29
Macclex Lowline Sill 914mm Aluminium - Exitex
from £20.34
OUM 4 Threshold 914mm - Aluminium - Exitex
from £21.44
Exitex Macclex 15/56 Threshold 914mm - Gold
from £25.89
Macclex 15/56 Threshold 914mm - Aluminium - Exitex
from £22.28
Macclex 15/2 Threshold 914mm - Aluminium - Exitex
from £20.30
Threshex Sill 933mm Black - Exitex
from £35.56
Threshex Sill 1220mm Black - Exitex
from £55.65
Macclex 15/2 Threshold 1219mm - Black - Exitex
from £28.00
Exitex Macclex 15/56 Threshold 1219mm - Black
from £39.86
LPD Pattern 20 Glazed Internal Door Pairs 1981 x 914mm Unfinished Oak
from £386.99
Spacepro 914mm Cashmere Shaker frame Single panel Mirror Sliding Wardrobe Door Kit
from £445.00
Product Description
Fitting Instructions: Threshold Section Check width between inside faces of the doorframe rebate and cut aluminium section to this size. (See Illustration) Notch the front ramped section as below. (See Illustration) This sill requires an under door clearance of 20mm. If necessary, remove door and trim to allow for this. Position the assembled sill between the doorframe and mark fixing points through countersunk holes. Remove sill, drill fixing holes and insert plugs. Apply sealing compound to underside groove at front of sill and where sill makes contact with doorframe and screw into place Upper Section Remove rubber seals from aluminium section and cut the aluminium to the door width. With door closed measure between exterior doorframe rebate less 6mm for deflector end caps. Notch the front section to this dimension as illustrated. Notches at both ends need to be equal. Refit rubber seals leave them extending by 3mm on each side. Nip the three groove ends of the seal carrier at the